
Properties:
- layer thickness 2-10 mm (15 mm for small areas)
- faster Strength (technological movement on a surface already through 6-7 hours)
- high strength - not less than 15 MPa
- fine-grained
- it spreads well and gives a smooth surface.
- high adhesion to substrates
- does not shrink
Packing: 25 kg
- Application
- Specifications
- Documents
- Reviews
- Features
Self-leveling mix for floors PSV-015 – ready dry mix for leveling and repair of small roughnesses of floors, practically all types of hydrophilic bases, resistant to deformation (cement, concrete, expanded concrete and other) with a layer from 2 to 10 mm (15 mm for small sections) residential or industrial buildings. Gives a flat, smooth, solid horizontal surface for laying out various coverings (parquet, laminate, carpet, linoleum, tile, etc.).
If there is a need to increase the elasticity, hydrophobic properties, as well as the adhesion of the solution to the base – to prepare the solution with the addition of concentrated emulsions: contact PL-125 and elastic PL-127.
If necessary, the alignment in the systems of heated floors to prepare the solution with the addition of elastic emulsion PL-127.
Technical passport
CONCLUSION OF STATE SANITARY AND EPIDEMIOLOGICAL EXAMINATION ON DRY MIXTURES PC POLIPLAST LLC
CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM POLYPLAST | GLUE MIXTURES
There are no reviews yet.
Structure | mixture of cement, gypsum mineral fillers and organic additives |
Appearance | homogeneous granular mixture gray without impurities |
aggregate size | no more than 0.63 mm |
mixing ratio | ~ 4.5-5.0 l of water per 25 kg (~ 0.19 + 0.01 liters of water to 1 kg) of dry mixture, depending on the desired consistency |
spreadability | at least 20 cm |
Thickness | 2-10 mm (and 15 mm for small areas) |
Temperature of the substrate and bases | +10 to +25 ° C |
Shelf life after mixing | at least 20 minutes |
Time of possible technological movement | 6-7 hours |
Adhesion to the substrate | not less than 0.5 MPa |
Shrinkage mortar | not more than 2.0 mm / m |
Performing further work | not earlier than 48 hours |
The compressive strength (after 3 days) | not less than 5.0 MPa |
Compression strength (after 28 days) | not less than 15.0 MPa |
Tensile strength in bending (after 28 days) | not less than 3.0 MPa |
Operating temperature of the solidified solution | from +1 to +45 ° C at a relative humidity less than 90% |
Consumption of dry mixture | ~ 1.7-1.8 kg / m² at 1 mm layer thickness |
Where to buy
For technical advice and the purchase of our products, please contact us by phone or fill out the application form
-
0 800 300 590 +38 044 331 59 21
+38 044 599 24 28
or
Submit your applicationSelect site language:
