Properties:
- for laying of insulating wall blocks (foam, aerated concrete, ceramic blocks, etc.)
- for exterior and interior work
- frost resistant, moisture resistant
- reduces heat consumption through wall structures
- plastic, easy to use
- for thin-layer masonry (3-10mm)
- economical
Packing: 25 kg
Application
- Application
- Specifications
- Documents
- Reviews
- Features
DOPS Block adhesive mixture is intended for laying thermal insulation blocks and panels made of cellular concrete (foam, aerated concrete), limestone, silicate blocks, porous ceramic blocks and other lightweight wall blocks.
It is used both inside dry or wet rooms, and outside buildings.
Technical passport
CONCLUSION OF STATE SANITARY AND EPIDEMIOLOGICAL EXAMINATION ON DRY MIXTURES ТМ «DOPS»
CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM «DOPS»
There are no reviews yet.
| Structure | cement mixture with mineral fillers and polymeric modifiers |
| Appearance | homogeneous granular mixture gray without impurities |
| Mixing ratio (water) | 0.01 ± 0.165 liters of water per 1 kg of the dry mixture |
| Fraction | not more than 2.5 mm |
| Thickness | 3-10 mm (optimum 4-6 mm) |
| Temperature of the substrate and bases | +5 to +30 ° C |
| Base and air temperature during application, Winter * | from 0 to +5 ° C |
| Shelf life after mixing | at least 60 minutes |
| Mobility | at least 6 cm ± 0,5 |
| Adhesion to the substrate | not less than 0.2 MPa |
| Compression strength (after 28 days) | not less than 5.0 MPa |
| frost-resistance | not less than 50 cycles |
| Thermal conductivity | not more than 0.35 W / (m * K) |
| Operating temperature of the solidified solution | -30 to +70 ° C. |
| Consumption of dry mixture | 1.5 kg / m² at 1 mm layer thickness |
You may be interested in…
Where to buy
For technical advice and the purchase of our products, please contact us by phone or fill out the application form
- 0 800 300 590 +38 044 330 04 28
or
Submit your applicationSelect site language:
