fbpx

Properties:

  • crack resistant
  • reinforced with microfibers
  • easy to apply up to 20 mm
  • for manual and machine application
  • for internal and external works
  • under all types of coverage
  • for leveling concrete bases of bowls of swimming pools, retaining walls, overlappings, facades
  • high strength

Packing: 25 kg

Application
  • Application
  • Specifications
  • Documents
  • Reviews
  • Features

Polymer-cement reinforced plaster PTSh-009 is a dry cement-based construction mixture used for repair and leveling of existing plastered surfaces. For installation of plaster and leveling of walls and ceilings from concrete, bricks, foam and gas blocks, cement-sand bases. For alignment of the sustained monolithic retaining walls, facades of buildings. For leveling the concrete foundations of swimming pool bowls before applying waterproofing and cladding. Due to the high content of polymer it is effective for repair of small cracks, deepenings and other defects, forms a strong basis for the subsequent finishing by all types of a tile (ceramic, gres, wide-format, concrete and others) a natural stone, waterproofing, decorative plasters, gluing of decorative elements. painting, etc. For use inside and outside buildings with a thickness of 2 to 20 mm per application.

When mixed with water, it forms a convenient solution, which is easily applied both manually and by machine.

! Do not use for floor repair.

 

 

 

Technical passport

CONCLUSION OF STATE SANITARY AND EPIDEMIOLOGICAL EXAMINATION ON DRY MIXTURES PC POLIPLAST LLC

CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM POLYPLAST | GLUE MIXTURES

Leave your review

There are no reviews yet.

Structurecement mixture with mineral fillers and polymeric modifiers
Appearancehomogeneous granular mixture gray without impurities
aggregate sizenot more than 0.8 mm
Temperature of the substrate and a base+ 5 ° C to + 30 ° C
mixing ratio0.24 + 0.01 L of water per 1 kg of the dry mixture
Shelf life after mixingat least 60 minutes
Mobility mortarat least 6cm
Adhesion to the substrate~ 0.5 MPa
Compressive strength after 28 daysnot less than 13 MPa
Tensile strength in bendingnot less than 4.0 MPa
water vapor permeabilityat least 0.05 mg / m × h × Pa
crack resistanceabsence of cracks in the layer of 20 mm thickness
frost-resistancenot less than 50 cycles
Operating temperature of the solidified solutionfrom -50 ° C to + 70 ° C
frost-resistancenot less than 50 cycles
Consumption of dry mixture~ 1.6 kg / m² at 1 mm layer thickness

Where to buy

For technical advice and the purchase of our products, please contact us by phone or fill out the application form

or

Submit your application
Calculator Where To Buy

Select site language: