Properties:
- Frost resistant, moisture resistant
- Good adhesion
- High strength
- Plastic, easy to use
- Wide range of applications
- Economical
Packing: 25 kg
- Application
- Specifications
- Documents
- Reviews
- Features
Construction mortar installation PSM-300 (100, 150, 200) – ready dry construction mix for laying (brick, rubble stone, slag cement blocks and similar materials), for installation of large concrete blocks, overlapping panels, wall panels, etc., repair of large defects and leveling, performance of screeds on strong bases, resistant to deformation (concrete, brick, cement-sand, etc.), facing of floors by a ceramic tile and tiles from a natural stone in a thick layer way. For external and internal works.
Available in 4 versions:
PSM-300 (30 MPa), PSM-200 (20 MPa), PSM-150 (15 MPa), PSM-100 (10 MPa)
* When used in temperature mode from 0 ° С to + 5 °С, the mixture marked “WINTER”
Technical passport
CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM POLYPLAST | GLUE MIXTURES
There are no reviews yet.
| Structure | cement mixture with mineral fillers and polymeric modifiers |
| Appearance | homogeneous granular mixture gray without impurities |
| Fraction | not more than 2.5 mm |
| Mixing ratio | ~ 3.75 liters of water per 25 kg (~ 0.15 L Vod 1 kg) dry blend (depending on the desired consistency and amount of filler) |
| Temperature of the substrate and bases | +5 to +30 ° C |
| Base and air temperature during application, Winter * | from 0 ° C to + 5 ° C |
| Shelf life of the mix after mixing | at least 90 minutes |
| Mobility | at least 4 cm |
| Adhesion of the surface | not less than 0.2 MPa |
| Compression strength (after 28 days) | PSM-100 – at least 10 MPa, PSM-150 – at least 15 MPa, PSM-200 – at least 20 MPa, PSM-300 – at least 30 MPa |
| Frost-resistance | 25-75 cycles |
| Consumption of dry mixture | ~ 2.0 kg / m × 1 mm thickness |
Where to buy
For technical advice and the purchase of our products, please contact us by phone or fill out the application form
or
Submit your application