fbpx

PRR-215

Fast hardening anchor mix

Properties:

  • high adhesion to concrete, metal
  • high-strength, self-expanding
  • quick hardening (5-7 min)
  • fiber reinforced
  • water resistant, frost resistant
  • for interior and exterior work
  • salt resistant

Packing: 25 kg

Application
  • Application
  • Specifications
  • Documents
  • Reviews
  • Features

Quick-hardening repair and assembly mixture PRR-215 is intended for fixing small metal, wood, plastic elements and embedded parts of building structures and equipment in concrete, masonry or cement mortars.

It is suitable for repairing cracks, seams, holes and holes with a width of up to 20-50 mm, as well as the formation of fillets in the contact angles of structures when performing waterproofing works.

The PRR-215 solution has high adhesion and strength, and a slight expansion in volume provides
tight seal of the cracks. If necessary to fix the mounting gaps width from 20 to 100 mm, to the mixture of PRR-215, you must additionally enter the filler fr. 5-10 mm in a 1: 1 ratio. In the preparation of mortar and additional introduction fill the amount of water does not increase. Adding a filler does not affect the timing
turing, but reduces the strength of the solution.

The PRR-215 mixture is especially recommended in cases:

  • installation of fastenings of drainpipes;
  • making a plug during installation of electrical wiring and installation of sockets;
  • fastening hooks, bolts for the installation of any equipment, including plumbing;
  • installation of metal and wooden frame elements, the installation of door and window hinges;
  • installation of anchors and dowels in concrete or masonry;
  • temporary repair of leaks in bathtubs, concrete and cast-iron pipes, pools and fountains.

Technical passport

CONCLUSION OF STATE SANITARY AND EPIDEMIOLOGICAL EXAMINATION ON DRY MIXTURES PC POLIPLAST LLC

CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM POLYPLAST | GLUE MIXTURES

Leave your review

There are no reviews yet.

Compositiona mixture of cements with mineral aggregates and polymer modifiers
Appearancehomogeneous granular mixture of gray color without impurities
Mixing ratiofor filling joints and cracks, the mobility grade P8 (plastic consistency): – 0.18 l / kg (4.5 l / 25 kg)

for filling voids, the mobility grade P14 (liquid consistency): – 0.22 l / kg (5.5 l / 25 kg)

Mortar shelf lifenot less than 5 minutes
Minimum hardening timesetting start: not earlier than 5 minutes

setting time: after ~ 6-7 minutes

Compressive strength (after 6 hours)not less than 10.0 MPa
Compressive strength (after 28 days)not less than 40.0 MPa
Bending tensile strength (after 6 hours)not less than 2.0 MPa
Bending tensile strength (after 28 days)not less than 8.0 MPa
Anchor Release Strengthnot less than 100.0 MPa
Frost resistancenot less than 50 cycles
Shrinkage no
Consumption~1.7 kg per 1 liter of filled volume

Where to buy

For technical advice and the purchase of our products, please contact us by phone or fill out the application form

or

Submit your application
Calculator Where To Buy