Properties:
- For leveling horizontal surfaces, sloping surfaces, repairing screeds
- For heated floors, "floating" floors
- Reinforced with polyamide fiber
- Layer thickness 10-100 mm
- Crack-resistant
- High-strength, frost-resistant, waterproof
- High adhesion to the base
- Easy to level, plastic
- Inside and outside buildings
Packing: 25 kg
- Application
- Specifications
- Features
- Reviews
PSP-031 mixture is intended for arranging high-strength floor screeds, repairing existing screeds, performing sloped screeds on strong, deformation-resistant bases (cement, concrete, expanded clay concrete, etc.) before applying leveling compounds, laying tiles and other coatings. It is used both when arranging a screed bonded to the base, and screeds on a separating layer, “floating” screeds (on heat- and sound-insulating boards, etc.), as well as in heated floor systems.
It is used inside dry or damp rooms and outside buildings. Due to the high fiber content and optimal granulometric composition, it has high strength and increased crack resistance.
It is applied with a layer thickness of 10 to 100 mm.
If it is necessary to increase the elasticity, hydrophobic properties or adhesion of the solution to the base, prepare the solution mixture using concentrated emulsions of the POLYPLAST TM: contact PL-125, elastic PL-127.
There are no reviews yet.
| Compound | mixture of cement with mineral fillers and polymer modifiers |
| Appearance | homogeneous free-flowing mass of gray color without foreign impurities |
| Aggregate size | no more than 1.25 mm |
| mixing ratio | 3 – 3.5 liters of water per 25 kg (~ 0.13 ± 0.01 liters of water per 1 kg) of dry mixture depending on the required consistency and amount of filler |
| Air and substrate temperature during application | from +5°С to +30°С |
| Shelf life from the start of mixing | at least 60 minutes |
| Layer thickness | from 10 to 100 mm |
| Adhesion to the substrate | not less than 0.5 MPa |
| Compressive strength (after 28 days) | not less than 25 MPa |
| Flexural Tensile Strength (At 28 Days) | not less than 4.5 MPa |
| Technological movement (with a layer thickness of 40 mm) | not earlier than 24 hours |
| Foundation strength | not less than 15 MPa |
| Implementation of further work | not earlier than 72 hours |
| Mortar Shrinkage | no more than 1.0 mm/m |
| Operating temperature of the hardened solution | from -30°С to +70°С |
| Frost resistance | at least 75 cycles |
| Dry mix consumption | -1.8-2.1 kg/m² per 1 mm layer thickness |
Where to buy
For technical advice and the purchase of our products, please contact us by phone or fill out the application form
- 0 800 300 590 +38 044 330 04 28
or
Submit your application