PRG-01

Mix waterproofing polymer cement "Hydrostop"

Properties:

  • for interior and exterior use
  • high adhesion to mineral bases
  • frost resistant, vapor permeable
  • protection of building structures from moisture and water
  • resistant to petroleum products
  • plastic, easy to prepare and use
  • economical

Packing: 25 kg

Application
  • Application
  • Specifications
  • Documents
  • Reviews
  • Features

The mixture of waterproofing polymer-cement PRG-01 “Hydrostop” is intended for waterproofing and protection of building structures, concrete, brick and plastered surfaces inside and outside buildings under the influence of water (up to 5 m water column) and moisture: walls and floors bathrooms, showers, pantries, basements and other wet and damp rooms.

Also foundations, terraces, balconies, flat roofs, parapets, pools, tanks, including for drinking storage water, other hydraulic structures and the like.

It is applied by water. Prevents negative consequences: destruction of building structures, increase of their thermal conductivity, appearance of mold, fungi, etc.

 

 

Technical passport

CONCLUSION OF STATE SANITARY AND EPIDEMIOLOGICAL EXAMINATION ON DRY MIXTURES PC POLIPLAST LLC

CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM POLYPLAST | GLUE MIXTURES

Leave your review

There are no reviews yet.

Compositiona mixture of cement with mineral aggregates and polymer modifiers
Appearancehomogeneous granular mixture of gray color without impurities
Aggregate sizeno more than 0,63 mm
Mixing ratiocoating waterproofing: ~ 6.25-6.75 L of water per 25 kg (~ 0.26 L ± 0.01 L per 1 kg of dry mix); plaster waterproofing: ~ 5.0-5.5 l of water per 25 kg (~ 0.21 l ± 0.01 l per 1 kg of dry mix)
Expiration date from the moment of mixingnot less than 60 minutes
Base adhesionnot less than 1.0 MPa
Compressive strength (after 28 days)not less than 12.0 MPa
Frost resistancenot less than 50 cycles
Water resistantnot less than 0.05 MPa (0.5 atm.) in 24 hours
Vapor permeabilitynot less than 0.03 mg / (m * h * Pa)
Hardened mortar operating temperaturefrom -30 to +60 ° С at a relative humidity of not more than 90%
Dry mix consumption~ 1.5-1.6 kg / m² per 1 mm of layer thickness ~ 3-8 kg per 1 m² (depending on the required layer thickness and application method)

Where to buy

For technical advice and the purchase of our products, please contact us by phone or fill out the application form

or

Submit your application
Calculator Where To Buy