PDR-074

Two-component epoxy waterproof high strength joint filler

Properties:

  • for outdoor work
  • waterproof
  • sealed
  • elastic
  • frost resistant, crack resistant, weatherproof
  • available in three colors
  • color resistance to aggressive atmospheric environment
  • resistant to grass overgrowing
  • high strength (not less than 45 MPa)

Packing: comp. A - 25 l + comp. B - 5 l

Application
  • Application
  • Specifications
  • Documents
  • Reviews
  • Features

High-strength waterproof joint filler PDR-074 is designed to fill joints with a width of 10 mm or more in clinker pavers (paving bricks), polygon stone or curly paving elements (FEMs) made of concrete and natural stone, the operation of which is designed for exposure to atmospheric factors and constant passage heavy transport.

High-strength joint filler PDR-074 is intended for joint use with a draining underlying layer PDR-070 (PDR-070 +), a waterproofing layer PRG-01 (PRG-02) and chute elements for water drainage when covering urban areas, streets of historic cities, carriageway of roads, parking lots, cargo areas, etc.

The PDR-074 mortar is resistant to efflorescence and damage caused by exposure to low temperatures, and is also resistant to the formation of cracks in wide joints and is intended for use on surfaces exposed to any operational loads.

! Available in three colors: gray, black, beige.

Technical passport

CONCLUSION OF STATE SANITARY AND EPIDEMIOLOGICAL EXAMINATION ON DRY MIXTURES PC POLIPLAST LLC

CONCLUSION OF THE LABORATORY OF RADIOLOGICAL HYGIENE TM POLYPLAST | GLUE MIXTURES

Leave your review

There are no reviews yet.

Structureсomponent A: a mixture of cement with mineral aggregates and polymer modifiers, сomponent B: epoxy resin
Colorgray, black, beige
Mixing ratiocomponent A = 25 kg : component B = 4.55 kg
Size of filler
up to 2 mm
The term mortar suitability~ 35 minutes
Layer thickness from 30 mm; when loading from transport – from 40 mm; when applied to a separate layer – from 50 mm
The width of the seamsfrom 10 mm (depth of not less than 30 mm); of 15 mm (depth 2 times the width of the seams)
Compressive strength (after 7 days)not less than 45 MPa
Tensile strength in bending (after 7 days)not less than 20 MPa
Adhesion to the substratenot less than 0.5 MPa
Frost-resistancenot less than 75 cycles
Time of possible technological movementnot earlier than 48 hours, after complete curing of the bedding layer at 23 ° C and humidity level at
50%
The ability to perceive the loadlight load – after 7 days; staff load – after 14 days
Consumption6-17 kg / m² depending on the depth and width of the seams

Where to buy

For technical advice and the purchase of our products, please contact us by phone or fill out the application form

or

Submit your application
Calculator Where To Buy