Properties:
- Deeply penetrates and strengthens the concrete base
- Increases the service life of poured floors
- Significantly increases the wear resistance of concrete floors
- High mechanical strength
- Increases adhesion to mineral bases
- Reduces the consumption of further coating with epoxy paint
- Moisture resistant, vapor permeable
- Does not contain organic solvents
- Transparent after drying
- Easy to apply
Packing: 1.5; 3; 5; 9 kg
- Application
- Specifications
- Features
- Reviews
Two-component epoxy soil EpoxyProGrunt is intended for priming concrete floors, screeds, poured floors, toppings, bricks, paving stones and other non-deformable mineral bases, with the aim of increasing strength and wear resistance, increasing the adhesion of subsequent layers to the base.
Creates a protective film on the surface of the base, which isolates concrete from the action of moisture, chemicals, weathering and mechanical damage, and at the same time significantly increases its service life.
It can be used as an independent fixing and strength-enhancing coating or as a preparation of mineral surfaces before applying finishing epoxy and polyurethane coatings.
Forms a transparent, smooth, homogeneous surface after drying, which significantly reduces the consumption of epoxy paint during subsequent application.
Designed for internal and external work on horizontal and vertical surfaces.
There are no reviews yet.
| Storage | Component A: Two-component composition based on water-emulsion epoxies. Component B: hardener |
| Color | colorless, transparent after drying |
| Density | ~ 1.1 kg/l component A+B |
| The pH indicator | 9,0-10,0 |
| Vapor permeability | V1 High ˃ 150 |
| Water permeability | W3 Low ≤ 0.1 kg/(m2 x h 0.5) |
| Limit value for VOC content | <75 g/L VOC |
| Time of life | up to 45 min |
| Temperature of base and air during application | from + 15 to +30 °C |
| Mixing ratio | 9:1 mass fractions can be diluted with water up to 10%, depending on the application conditions |
| Cost | 0.1-0.2 kg/m2 depending on the type of surface |
| Drying time, at an air temperature of +20 °C and humidity of 55% | To apply the next layer of paint – 12-24 hours Mechanical loads – after 3-7 days |
| Diluent | Water* |
Where to buy
For technical advice and the purchase of our products, please contact us by phone or fill out the application form
- 0 800 300 590 +38 044 330 04 28
or
Submit your application