Properties:
- high adhesion to mineral bases
- protection of structures against the action of water (pressure up to 5 m of water column)
- vapor permeable, frost resistant
- resistant to oil products
- suitable for drinking water tanks
- for internal and external works
Packing: 25 kg
- Application
- Specifications
- Features
- Reviews
The one-component waterproofing mixture DOPS Hydrobarrier is intended for the installation of a waterproofing layer on strong mineral bases resistant to deformation (concrete bases, brickwork, cement-sand screeds, plasters, etc.), which are under periodic or constant influence of moisture and water with a hydrostatic pressure of up to 5 m of the water column inside or outside buildings (foundations, terraces, balconies, flat roofs, walls and floors of toilets and showers, tanks with water, including drinking water, other hydraulic structures, etc.) before plastering or cladding during new construction and reconstruction . The mixture reliably protects the base both from the direct negative flow of water and from seepage with an aqueous solution, which significantly increases the service life of the structure and its frost resistance, prevents an increase in thermal conductivity and prevents the occurrence of fungi and mold. It is applied from the side of water action
There are no reviews yet.
| Composition | mix cement with mineral additives and polymer modifiers |
| Starry look | homogeneous barn owl without third-party houses |
| Color | gray with a hint |
| mixing ratio | coating waterproofing: ~4.75 – 5.25 liters per 25 kg (~0.20 liters ±0.01 liters per 1 kg of dry mix) plaster waterproofing: ~4.25 – 4.75 liters per 25 kg (~0.18 liters ±0.01 liters per 1 kg of dry mix) |
| Aggregate size | no more than 0.63 mm |
| Shelf life from the start of mixing | at least 60 minutes |
| Air and substrate temperature during application | from +5°С to +30°С |
| Mixing water temperature | from +15 °С to +20 °С |
| Adhesion strength to the substrate after exposure to air-dry conditions | not less than 1.0 MPa |
| Adhesion strength to the substrate after soaking in water | not less than 1.0 MPa |
| Compressive strength after 28 days | not less than 12 MPa |
| Shrinkage | no more than 2.0 mm/m |
| Waterproof | not less than 0.05 MPa (0.5 atm) for 24 hours |
| Vapor permeability | not less than 0.03 mg/(m*h*Pa) |
| Time of technical movement | at least 3 days |
| Frost resistance | at least 75 cycles |
| Operating temperature of the hardened solution | from -30 °С to +70 °С |
| Dry mix consumption | ~1.45 – 1.5 kg/m²/mm ~2.9 – 7.5 kg per 1 m² (depending on required layer thickness and application method) |
Where to buy
For technical advice and the purchase of our products, please contact us by phone or fill out the application form
- 0 800 300 590 +38 044 330 04 28
or
Submit your application